Canyon 98-161 Assembly Instructions Manual - Page 10
Browse online or download pdf Assembly Instructions Manual for Indoor Furnishing Canyon 98-161. Canyon 98-161 14 pages. Cottage colors collection bunk bed
Print Page
1.- ASSEMBLE BED, USING ONE HEADBOARD (M), ONE FOOTBOARD (N) AND TWO SIDE RAILS (F).
2.- INSERT TWO CROSS DOWELS (I) IN ACCESS HOLE INSIDE THE SIDE RAIL, ALIGN THE CROSS DOWEL NUT, MAKE SURE THE GROOVE IS HORIZONTAL, SEE FIG.9
3.- ATTACH TWO SIDE RAILS (F), TO HEADBOARD (M) & FOOTBOARD (N), INSERTING TWO 80MM FLAT HEAD BOLTS (H) INTO TO HEADBOARD&FOOTBOARD HOLES, USE THE 5MM ALLEN WTENCH (J) TO TIGHTEN BOTH
( DO NOT TIGHTEN COMPLETELY UNTIL ALL PIECES ARE CONNECTED TOGETHER ),
FLAT HEAD BOLTS
4.- PLACE 4 SLATS (K) ON TOP SIDE RAIL CLEATS, ONE SLAT IN BOTH HEADBOARD & FOOTBOARD ENDS, PUSH THE SLATS AGAINST THE BED END POST ( FIG. A ) AND TWO SLATS IN THE MIDDLE AT EQUAL DISTANCE
FROM THE END SLATS, THEN EACH SLAT MUST BE FASTEN WITH ONE 1 1/4" SCREW (L), SEE FIG.12
5.- PLACE IT UNDER THE STEP BUNK BED, AS SHOWN IN
TIPS : SEE ILLUSTRATION BELOW
1.- USE THE LONG END OF THE ALLEN WRENCH TO FASTEN
BOLTS LOOSELY AND QUICKLY.
2.- USE THE SHORT END OF THE ALLEN WRENCH FOR FINAL
TIGHTENING.
TIPS # 1
1.- ALIGN THE PRE - DRILLED HOLES IN LONG PART OF METAL HOOKS BRACKETS ( P ) WITH THE PRE - DRILLED HOLES IN THE LADDER ( O ), THEN SECURE WITH 1" SCREWS ( Q) USING PHILLIPS HEAD SCREWDRIVER
( NOT INCLUDED )
,
SEE FIG. B, AND HOOK THE LADDER IN THE PROPER POSITION, ADJUST AND ALIGN THE PRE - DRILLED HOLES IN THE SHORT PART OF METAL HOOKS ON TOP SIDE RAIL, THEN SECURE THE
CONFIGURATION # 1
LADDER, AS SHOWN IN
FIG. B
REV 01 02/08/16
CONFIGURATION # 2
TIPS # 2
CONFIGURATION # 2
AND
CANYON FURNITURE COMPANY.
TWIN/FULL BED ASSEMBLY
REPEAT THE SAME PROCESS AT ALL FOUR CORNERS, SEE FIG.12
( USE ONE 4 PCS SLAT PACK FOR 98-707 (98-645) )
LADDER ASSEMBLY
PAGE 4 OF 5
AND
( USE ONE 4PCS SLAT PACK FOR 98-709 (98-646) )
FIG. 15
KIS01130