Doughpro DP2350MBZ Operator's Manual - Page 3

Browse online or download pdf Operator's Manual for Power Tool Doughpro DP2350MBZ. Doughpro DP2350MBZ 14 pages. Automatic dough press

Print Page

WARNING

Avoid touching hot surfaces

while operating the machine.

CAUTION

During normal operation, the

base of the machine must be

installed or placed above the wall

socket.

CAUTION

When servicing or cleaning the

machine, make sure that the

power cord is removed from the

wall socket.

Operation Timer/Temperature

Control

Fig. A

Solid State Controller

This controller has three (3) control

features:

1. Temperature – May be set from

100°-425°F (38°-163°C)

2. Time – Time may be set from 1

second to 10 minutes.

3. Counter – Cycle counter counts

the number of applications from

1 to

9999

(see additional Notes –

Counter).

4. "2Lower" (Fig. A) Refers to

models using upper and lower

heated surfaces.

Controller Operation

1. Viewing the Modes of Operation:

• To view the set points of

temperature, timer and counter,

press MODE button to view the

desired mode of operation.

2. Changing Temperature:

• Press MODE button until

temperature is displayed.

• Press and hold SET button

while pressing the UP (↑) and

DOWN (↓) arrow buttons to

desired temperature setting.

3. Changing Time:

• Press MODE button until time

is displayed.

• Press and hold SET button

while pressing the UP (↑) and

DOWN (↓) arrow buttons to

desired timer setting.

The DISENGAGE switch may

be pressed anytime during a

cycle, and the cycle will stop

immediately, and the timer will

reset.

4. Resetting the Counter

• Press MODE button until the

counter is displayed.

• To Reset the Counter (# of

Cycles), simultaneously push

UP (↑) or DOWN (↓) arrow

buttons (approx. 5 seconds).

PRESSING DOUGH:

For best results, your dough should be

proofed before pressing, but it will also

press directly out of your refrigerator.

Flour is not required to press a crust

and should not be dusted on any part of

the machine.

WARNING

Press must be level on counter or

table in order to function properly

-2-

DP1300 2/04

2/10