Douglas Lighting Controls WRS-2224 Instruction Manual - Page 10
Browse online or download pdf Instruction Manual for Scanner Douglas Lighting Controls WRS-2224. Douglas Lighting Controls WRS-2224 20 pages. Programmable relay scanner
Print PageSetup: Flick Warn Option
FLICK WARN OPTION
Allows any relay group to have the FLICK WARN feature.
FLICK WARN warns occupants that the lights will be switched
OFF in 5 minutes.
Occupants can cancel the OFF sweep for the local circuit by
flicking the local switch. Or, they can cancel the OFF sweep for
the entire group by pressing the group's input switch once.
12
PM
9
3
OFF
6
OFF Signal
To Assign the Flick Warn Option:
1. Make sure the output relays are properly connected to the output
terminals and that the group switches and/or timer outputs are
properly connected to the input terminals.
2. Make sure NORMAL MODE is selected. Its top indicator LED should
be ON.
3. Use the INPUT SELECT button to select the desired group #1-5
(when its indicator INPUT LED is ON).
4. Press the PROGRAM MODE select button. Its indicator LED will
begin flashing. If you have not already done so, select the output
relays that belong to that input's group.
5. Press the OPTIONS MODE select button once. The FLICK WARN
indicator LED will turn on. (Pressing the OPTIONS MODE button
will cycle the selections from FLICK WARN to TIME OUT to TIME
OUT with FLICK WARN back to NO SELECTION.)
6. Return to NORMAL mode.
7. Repeat steps #3 - 6 to assign the FLICK WARN option to another
group.
8. For any group assigned the FLICK WARN option, the FLICK WARN
indicator LED will be ON whenever the group is selected and the
FLICK/TIME-OUT ACTIVE LED will flash whenever the flick warning
operation is occurring.
To De-Assign the Flick Warn Option:
1. Select the group (with INPUT SELECT).
2. Go to PROGRAM mode.
3. Press the OPTIONS button (usually 3 times) so that both the
FLICK WARN LED and TIME OUT LED are OFF.
4. Return to NORMAL mode.
WRS-2224: Directions & Applications
FLICK WARN Sequence
1
2
Sw
Lights flash to
Occupant has
warn of OFF
5 minutes to
cancel OFF
Output Mode
Select Button
NOTE:
page 8
3
4
Sw
Sw
If cancelled,
If not cancelled,
lights stay ON
Time Out
LED
Flick Warn
LED
Program Mode
Select Button
Input
Select
Button
Assigning the FLICK WARN option to a relay group that
controls any HID lighting is NOT RECOMMENDED.
(HID lights require more than 5 minutes to turn ON after
being turned OFF.)
Sw
lights go OFF
Normal Mode
Select Button
Flick/
Time Out
Active LED
Input
LEDs
DOUGLAS
lighting controls