Dahua VTH1550CH Quick Install Manual - Page 3

Browse online or download pdf Quick Install Manual for Intercom System Dahua VTH1550CH. Dahua VTH1550CH 13 pages. How to connect vto and vth
Also for Dahua VTH1550CH: Connection Manual (16 pages)

Print Page

VTO Camera Configuration

With a PC or Laptop connected to the network switch, run the Dahua config tool to find the VTO unit. By default the VTO has an IP

address of 192.168.1.110, this can be changed if required via the config tool or within the VTO web browser.

Select the Local Config tab and change Device Type to Villa Station. Click OK to save the setting.

Select the Logout option on the left menu and click Reboot Device, this will restart the VTO.

VTH Monitor Configuration

To configure the VTH unit use the built in menu within the monitor itself. VTH units do not support web browser configuration.

Select Settings > Project Settings and input the engineer password: 002236 (default)

For DHI-VTH5221D units hold down the Settings button for 5 seconds and enter the engineer password: 888888 (default)

The Product Info menu is used to set the room number of the VTH and to configure the unit as a Master or Extension unit. If

only a single VTH is being used in the system, then this should be set to Master and a room number chosen. Adding multiple

VTH units is covered on page 5.

Tel: +44 (0)1457 874 999 | Fax: +44 (0)1457 829 201 | Email: [email protected] | Online: www.cop-eu.com