Dahua VTH1550CH 빠른 설치 매뉴얼 - 페이지 3
{카테고리_이름} Dahua VTH1550CH에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dahua VTH1550CH 13 페이지. How to connect vto and vth
Dahua VTH1550CH에 대해서도 마찬가지입니다: 연결 매뉴얼 (16 페이지)
페이지 인쇄
VTO Camera Configuration
With a PC or Laptop connected to the network switch, run the Dahua config tool to find the VTO unit. By default the VTO has an IP
address of 192.168.1.110, this can be changed if required via the config tool or within the VTO web browser.
Login to the VTO via the computers web browser. Username: admin Password: admin
Select the Local Config tab and change Device Type to Villa Station. Click OK to save the setting.
Select the Logout option on the left menu and click Reboot Device, this will restart the VTO.
VTH Monitor Configuration
To configure the VTH unit use the built in menu within the monitor itself. VTH units do not support web browser configuration.
Select Settings > Project Settings and input the engineer password: 002236 (default)
For DHI-VTH5221D units hold down the Settings button for 5 seconds and enter the engineer password: 888888 (default)
The Product Info menu is used to set the room number of the VTH and to configure the unit as a Master or Extension unit. If
only a single VTH is being used in the system, then this should be set to Master and a room number chosen. Adding multiple
VTH units is covered on page 5.
3
Tel: +44 (0)1457 874 999 | Fax: +44 (0)1457 829 201 | Email: [email protected] | Online: www.cop-eu.com