AmpliVox SSB1240 User Manual - Page 5
Browse online or download pdf User Manual for Speaker System AmpliVox SSB1240. AmpliVox SSB1240 6 pages. Duo tandem line array
WIRELESS HANDHELD MICROPHONE—MODEL S1695
If you are using the Amplivox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom sec-
tion of microphone and insert 2 - "AA" 1.5 Volt alkaline batteries.
Because the microphone has an Auto Sync function, you first select channel you wish to use on the receiver. Then
press the ASC button (D), the IR light will start to flash. Turn on microphone and point end (6) of microphone at the
flashing IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.
BATTERIES
1. Hold the body of microphone in hand and twist off bottom
section of microphone.
2. Insert two "AA" batteries.
3. Twist bottom section back on to microphone.
BATTERY STATUS
The life expectancy of the two batteries is about 10 hours. When
the "BATTERY" symbol on the display screen keeps flashing
the batteries should be replaced immediately.
Microphone Operation and Status Display
Functions
1) Interchangeable Microphone Head
2) LCD Screen
3) Power / Mute Control Switch
4) Select Button
5) Microphone Input Sensitivity Adjust-
ment—is used to set the gain of microphone.
If you are a soft talking speaker you will need
to turn the control counter clockwise. Turn
clockwise if you are a loud talker. Use plastic
screwdriver that is supplied.
TURN ON MICROPHONE: Push and hold the "POWER/MUTE" (3) button until
LCD screen lights up.
TO MUTE: Press "POWER/MUTE" button twice to MUTE. Channel number will
flash when muted. Press button again twice to remove "MUTE".
TURN OFF MICROPHONE: Push and hold the "POWER/MUTE" (3) button for 2
seconds to turn microphone "OFF".
SELECT CHANNEL: Press and hold the "SELECT" (4) button for 2 seconds
until you only see the word Channel and channel number. To change channel,
when flashing, press the "SELECT" (4) button until you reach the desired chan-
nel. Flashing will stop after 10 seconds and channel is now set.
LOCK / UNLOCK CHANNEL: Push the "POWER/MUTE" (3) button and
"SELECT" button at the same time to lock or unlock channel. When locked, chan-
nel cannot be changed. "LOCKED" symbol appears in upper left-hand corner.
5
6