AmpliVox SSB1240 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System głośników AmpliVox SSB1240. AmpliVox SSB1240 6 stron. Duo tandem line array

WIRELESS HANDHELD MICROPHONE—MODEL S1695

If you are using the Amplivox S1695 Wireless Handheld Microphone Transmitter, screw off the lower bottom sec-

tion of microphone and insert 2 - "AA" 1.5 Volt alkaline batteries.

Because the microphone has an Auto Sync function, you first select channel you wish to use on the receiver. Then

press the ASC button (D), the IR light will start to flash. Turn on microphone and point end (6) of microphone at the

flashing IR light on receiver and the microphone will auto sync to the same channel as selected on the receiver.

BATTERIES

1. Hold the body of microphone in hand and twist off bottom

section of microphone.

2. Insert two "AA" batteries.

3. Twist bottom section back on to microphone.

BATTERY STATUS

The life expectancy of the two batteries is about 10 hours. When

the "BATTERY" symbol on the display screen keeps flashing

the batteries should be replaced immediately.

Microphone Operation and Status Display

Functions

1) Interchangeable Microphone Head

2) LCD Screen

3) Power / Mute Control Switch

4) Select Button

5) Microphone Input Sensitivity Adjust-

ment—is used to set the gain of microphone.

If you are a soft talking speaker you will need

to turn the control counter clockwise. Turn

clockwise if you are a loud talker. Use plastic

screwdriver that is supplied.

TURN ON MICROPHONE: Push and hold the "POWER/MUTE" (3) button until

LCD screen lights up.

TO MUTE: Press "POWER/MUTE" button twice to MUTE. Channel number will

flash when muted. Press button again twice to remove "MUTE".

TURN OFF MICROPHONE: Push and hold the "POWER/MUTE" (3) button for 2

seconds to turn microphone "OFF".

SELECT CHANNEL: Press and hold the "SELECT" (4) button for 2 seconds

until you only see the word Channel and channel number. To change channel,

when flashing, press the "SELECT" (4) button until you reach the desired chan-

nel. Flashing will stop after 10 seconds and channel is now set.

LOCK / UNLOCK CHANNEL: Push the "POWER/MUTE" (3) button and

"SELECT" button at the same time to lock or unlock channel. When locked, chan-

nel cannot be changed. "LOCKED" symbol appears in upper left-hand corner.