AIRSLED AM1200 Owner's Manual - Page 3

Browse online or download pdf Owner's Manual for Industrial Equipment AIRSLED AM1200. AIRSLED AM1200 8 pages. Light-duty appliance mover

Print Page

POSITIONING THE AIR BEAMS

•

Appliance Mover air beams are 1/8" thick. There must be enough clearance between the floor and the

load's base to allow the air beams to be freely slid into place. DO NOT force the air beams under the

load.

•

If the gap between the air beam and load's base is greater than 1 ½", the air beams may not produce

the necessary lift. To address this issue, Airsled offers SPACER STICKS and ADJUSTABLE

SPACER SYSTEMS. More information on these items can be found on www.Airsled.com. Wood

blocking can also be used to bridge the gap.

•

Slide the air beams under the load. See figure 1.

•

Placement of the air beams will generally be done either through front or side access. See figure 2 &

3. Optimal Airsled performance will be achieved by centering the air beams under the load so that the

same length of air beam extends from the front as well as the back. Pushing the air beams as wide

apart as possible is also recommended.

Figure 1

•

The air beams for the Light Duty Appliance mover are 7" wide x 36" long and are recommended for

loads whose base exceed 32" in length.

CONNECTING THE AIRSLED COMPONENTS

No tools are required to connect or disconnect the Airsled components. All connections between the

blower, lead hose, Tee connector, supply hoses and air beam inlets should be done by hand until a snug

fit. See figure 4.

NOTE: When connecting or

disconnecting the supply

hoses to the air beams, do so

by grabbing the:

Solid hose end

Solid plastic inlet

Pulling only the soft hoses

may damage your system.

Figure 2

Figure 4

70 – A Aleph Dr.

Support Email:

Toll Free Number: 1-800-AIRSLED (1-800-247-7533)

Newark, DE 19702

Page 2 of 7

Figure 3