AIRSLED AM1200 Руководство пользователя - Страница 3
Просмотреть онлайн или скачать pdf Руководство пользователя для Промышленное оборудование AIRSLED AM1200. AIRSLED AM1200 8 страниц. Light-duty appliance mover
Печатать страницуPOSITIONING THE AIR BEAMS
•
Appliance Mover air beams are 1/8" thick. There must be enough clearance between the floor and the
load's base to allow the air beams to be freely slid into place. DO NOT force the air beams under the
load.
•
If the gap between the air beam and load's base is greater than 1 ½", the air beams may not produce
the necessary lift. To address this issue, Airsled offers SPACER STICKS and ADJUSTABLE
SPACER SYSTEMS. More information on these items can be found on www.Airsled.com. Wood
blocking can also be used to bridge the gap.
•
Slide the air beams under the load. See figure 1.
•
Placement of the air beams will generally be done either through front or side access. See figure 2 &
3. Optimal Airsled performance will be achieved by centering the air beams under the load so that the
same length of air beam extends from the front as well as the back. Pushing the air beams as wide
apart as possible is also recommended.
Figure 1
•
The air beams for the Light Duty Appliance mover are 7" wide x 36" long and are recommended for
loads whose base exceed 32" in length.
CONNECTING THE AIRSLED COMPONENTS
No tools are required to connect or disconnect the Airsled components. All connections between the
blower, lead hose, Tee connector, supply hoses and air beam inlets should be done by hand until a snug
fit. See figure 4.
NOTE: When connecting or
disconnecting the supply
hoses to the air beams, do so
by grabbing the:
Solid hose end
Solid plastic inlet
Pulling only the soft hoses
may damage your system.
Figure 2
Figure 4
70 – A Aleph Dr.
Support Email:
Toll Free Number: 1-800-AIRSLED (1-800-247-7533)
Newark, DE 19702
Page 2 of 7
Figure 3