Bosch 300 Series Installation Manual - Page 12

Browse online or download pdf Installation Manual for Dishwasher Bosch 300 Series. Bosch 300 Series 36 pages. Built-in wall ovens
Also for Bosch 300 Series: Instructions For Use Manual (40 pages), User Manual (21 pages), Installation Manual (6 pages), Installation Manual (32 pages), Use And Care Manual / Installation Instructions (40 pages), Operating Instructions Manual (50 pages), Quick Start And Safety Manual (7 pages), Installation Manual (28 pages), Quick Start Manual (7 pages), Use And Care Manual (32 pages), Quick Start And Safety Manual (7 pages), Service Manual (36 pages), Quick Start And Safety Manual (13 pages)

Print Page

Adapting microwave blower for wall venting

Remove and save the screws holding the blower

motor and the blower plate. Lift up the blower plate

and put it aside.

Carefully pull out the blower unit and rotate 90º so that

fan blade openings are facing out the top of the

microwave.

Rotate the blower unit counterclockwise 180º.

Gently remove the wires from the grooves. Reroute the

wires through the grooves on other side of the blower

unit. Rotate blower unit 90º so that fan blade openings

are facing out the back of the microwave.

CAUTION

Do not pull or stretch the blower unit wiring. Make

sure the wires are not pinched, and that they are

properly secured.

Place the blower unit back into the opening.

Replace the blower plate and secure with the screws

removed in Step 1.

Use tin snips to cut and remove knockouts from the

rear plate of the microwave oven. Discard knockouts.

Be careful not to distort the plate.

Attach the exhaust adapter to the rear of the oven by

sliding it into the guides. Push in securely until it is in

the lower locking tabs. Make sure the damper hinge

swings freely.

Preparing cabinet

Remove power to outlet.

Remove all contents from upper cabinet.

Tape the TOP CABINET TEMPLATE onto the bottom

surface. Make sure the template centerline aligns with

the vertical line on the wall. Rear wall arrows must be

against rear wall.

Note: For recessed cabinet bottom, trim the template

edges so that it fits inside the recessed area. The

template has trim lines to use as guides.

Drill 3\8" (9,5 mm) holes at "A", "B" and "C".

Note: Wear safety goggles when drilling holes in the

cabinet bottom.

Cut out the 2" (50,8 mm) hole at "D". This hole is for

the power supply cord.

Note: If the cabinet is metal, use the nylon grommet

around the opening to protect the cord.