Bosch Vision 800 Series Service Manual - Page 15

Browse online or download pdf Service Manual for Washer Bosch Vision 800 Series. Bosch Vision 800 Series 43 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Installation Instructions Manual (28 pages), Service Manual (36 pages)

Print Page

58300000202443_ARA_EN_C

To remove the Solo microwave or Speed microwave oven...

1. Remove power to the oven.

2. Remove the screws securing the right and left side trim pieces

to the cabinetry.

3. Carefully slide the combination unit completely out of the

cabinet cutout.

4. Proceed to step 6 if servicing a Speed microwave oven

5. Unplug the power cord from the receptacle if servicing a Solo

microwave then proceed to step 7.



NOTICE

The 120VAC receptacle snaps into the rear housing cover.

Gain access to the receptacle's electrical fuse and wiring termination

by removing the top front cover.

Figure 8 120VAC receptacle and harness (HBL87M52UCC only)

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JANUARY 2018

6. Disconnect the feeder wires from the terminal block (see

Figure 7): only necessary if a work table is not nearby, and the

5' length of conduit/wire will not be sufficient.

7. Remove the front decorative trim that is secured to the

universal brackets with two screws.

8. Remove the six screws which secure the microwave to the

right and left universal brackets

Speed or Solo MW oven

Figure 9 Removing screws securing microwave to universal brackets on top of wall oven.

9. Carefully lift the microwave off the universal brackets, and set

aside.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 800 Series Built-in Wall Ovens

Universal Brackets

Wall Oven

Page 15 of 43

800 944-2904