Bosch Vision 800 Series Service Manual - Page 17

Browse online or download pdf Service Manual for Washer Bosch Vision 800 Series. Bosch Vision 800 Series 43 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Installation Instructions Manual (28 pages), Service Manual (36 pages)

Print Page

58300000202443_ARA_EN_C

3. Partially close the oven door until it is open about 7" and

catches on the hinge-stop levers.

4. Using both hands, lift door upward and outward to disengage

the hinges from the hinge receiver slots.

5. Set the door aside on a protected flat surface.

To reinstall the door...

1. Hold the door firmly in both hands and position the hinges in

the hinge receivers, so that the slot in the base of the hinge (A)

engages with the hinge receiver (B).

Figure 11 Position the hinge in the hinge slot

2. Tilt the door inward and slide the hinges into place; the hinges

should catch and the door should remain in place.

3. Open door fully to expose the hinge levers and hinge receiver

slots.

4. Flip the right and left hinge levers forward until they are fully

closed.

Figure 12 Closing hinge lever

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JANUARY 2018

5. Open and close the door carefully to confirm that the door is

installed correctly and securely, and does not appear to be

askew when closed.

6. Carefully close and open door to check operation.

6.1.2

The doors on Bosch 800 series ovens are soft-close, and operate

using one dampen hinge and one spring hinge. The hinges are

offered in service kits which include both the RH and LH hinges;

always replace hinges in pairs.



NOTICE

The dampen hinge has a cylinder inside which holds oil that acts as

the dampening fluid and causes the soft-close effect. The oil must be

in the bottom of the cylinder. If the door does not close softly, allow

the hinge time to recover in the vertical position (door closed) for 15-

30 minutes, then re-test door operation. See bulletin packed with

hinge kits for more information.

To access the hinges...

1. Remove the door as described in the Removing and Reinstalling

the Door section.

2. With the porcelain-coated door liner up, remove the two screws on

each side of the door liner.

3. Remove the screws along the bottom of the door assembly.

Figure 12 Removing door liner screws

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 800 Series Built-in Wall Ovens

Replacing Hinges

Page 17 of 43

800 944-2904