Bosch WAE1826KBC Instructions For Installation And Use Manual - Page 18

Browse online or download pdf Instructions For Installation And Use Manual for Washer Bosch WAE1826KBC. Bosch WAE1826KBC 20 pages. Front-loading washing machine

Minor faults with simple solutions

!
Repairs should be carried out by Bosch customer service or authorised technicians only. Any
erroneous or incorrect repair may seriously endanger or cause considerable harm to the user.
Malfunction
The function indicator does not come
on
The wash cycle does not start
The wash cycle does not start
No water can be seen in the drum
Washing result is unsatisfactory
Foam comes out of the detergent
drawer
Foam is visible after the final rinse
Strange motor noises
Pump noises
The machine vibrates when washing
or spinning
The appliance does not spin or does
not empty the water used
The door will not open
Water does not enter the washing
machine
Alterations in the time remaining
The screen shows «E2»
18 en
Possible cause / Remedy
The machine's plug is not connected or not properly connected
to the power point. The fuse has blown. Electrical power failure.
Start
M» button has not been pressed. The door is not
The «
properly closed (the «
tors flash).
Start
M» button has not been presses. The door is not prop
The «
erly closed (screen shows «
This is not a malfunction. There is water in the appliance but it is
beneath the visible area. The electronic control reduces
consumption while maintaining all services.
Abnormally high degree of soiling. Insufficient detergent.
Measure out the detergent in line with the manufacturer's
instructions. Select the most suitable wash programme for the
laundry.
Too much detergent has been used. Disconnect the appliance for
5
10 minutes. To prevent the build-up of foam, put a
dessertspoon of softener mixed with half a litre of water in the
detergent drawer. Reduce the amount of detergent used in your
next wash.
Some detergents produce a large quantity of foam although this
has no effect on the rinsing result.
This is not a malfunction. During the heating stage, the motor
produces noises characteristic of starting.
This is not a malfunction. These noises are characteristic of the
machine starting and the pump discharging.
The transport securing devices have not been removed. Note the
instructions for installation. The adjustable feet on the machine
were not fixed during installation. Level the machine and fix the
supports according to the installation instructions.
The drain pump is blocked; see «Cleaning the water drain pump»the
drain pipe is bent or blocked (the screen shows «E
cases).
The security feature is activated. The option ò" has been
selected.
The water inlet filters are dirty «Cleaning the water inlet filters»; the tap
is turned off (the screen shows «E
This is not a malfunction. The time remaining may be extended or
reduced slightly during the washing cycle, depending on
automatic adjustments or user selections (see «Screen»).
Motor fault. Contact the After Sales Service.
-Wash Q
Start
d
» and «
E3
»).
5
» in both cases).
Rinse
K» indica
6
» in both