Bosch WAE1826KBC Manual de instruções de instalação e utilização - Página 18

Procurar online ou descarregar pdf Manual de instruções de instalação e utilização para Máquina de lavar roupa Bosch WAE1826KBC. Bosch WAE1826KBC 20 páginas. Front-loading washing machine

Imprimir página

Minor faults with simple solutions

Repairs should be carried out by Bosch customer service or authorised technicians only. Any

erroneous or incorrect repair may seriously endanger or cause considerable harm to the user.

Malfunction

The function indicator does not come

The wash cycle does not start

No water can be seen in the drum

Washing result is unsatisfactory

Foam comes out of the detergent

drawer

Foam is visible after the final rinse

Strange motor noises

Pump noises

The machine vibrates when washing

or spinning

The appliance does not spin or does

not empty the water used

The door will not open

Water does not enter the washing

machine

Alterations in the time remaining

The screen shows «E2»

18 en

Possible cause / Remedy

The machine's plug is not connected or not properly connected

to the power point. The fuse has blown. Electrical power failure.

Start

M» button has not been pressed. The door is not

The «

properly closed (the «

tors flash).

Start

M» button has not been presses. The door is not prop

The «

erly closed (screen shows «

This is not a malfunction. There is water in the appliance but it is

beneath the visible area. The electronic control reduces

consumption while maintaining all services.

Abnormally high degree of soiling. Insufficient detergent.

Measure out the detergent in line with the manufacturer's

instructions. Select the most suitable wash programme for the

laundry.

Too much detergent has been used. Disconnect the appliance for

10 minutes. To prevent the build-up of foam, put a

dessertspoon of softener mixed with half a litre of water in the

detergent drawer. Reduce the amount of detergent used in your

next wash.

Some detergents produce a large quantity of foam although this

has no effect on the rinsing result.

This is not a malfunction. During the heating stage, the motor

produces noises characteristic of starting.

This is not a malfunction. These noises are characteristic of the

machine starting and the pump discharging.

The transport securing devices have not been removed. Note the

instructions for installation. The adjustable feet on the machine

were not fixed during installation. Level the machine and fix the

supports according to the installation instructions.

The drain pump is blocked; see «Cleaning the water drain pump»the

drain pipe is bent or blocked (the screen shows «E

cases).

The security feature is activated. The option ò" has been

selected.

The water inlet filters are dirty «Cleaning the water inlet filters»; the tap

is turned off (the screen shows «E

This is not a malfunction. The time remaining may be extended or

reduced slightly during the washing cycle, depending on

automatic adjustments or user selections (see «Screen»).

Motor fault. Contact the After Sales Service.

-Wash Q

Start

» and «

»).

» in both cases).

Rinse

K» indica

» in both