Draper D20NS1700 User Manual - Page 13

Browse online or download pdf User Manual for Power Tool Draper D20NS1700. Draper D20NS1700 20 pages. 20v brushless nibbler. d20 multi-tool battery system

Print Page

8. PREPARING THE NIBBLER

To install a cutter head, the cutter needs to be

located in the plunger first, then slide the correct

cutter head over the cutter and locate in the tool, this

may be tricky at first as the cutter needs to line up

accurately to locate the cutter head, it may be easier

to allow the cutter to hang from the plunger (Fig.8.)

and slide the cutter head into place from underneath

with the rapid cutter you may need to slacken the

bolts holding the upper guide on to allow it to slide

easily into place (Fig.10.). You also need to line up

the groove in the cutter with the rear of the cutter

head (Figs.9-10). Don't tighten the bolts up too much

or you may restrict the removal of the cutter head.

Once the cutter head is fully located rotate the head

until it locks into position (the freehand head locks in

two positions 180deg apart and the rapid nibbler

head locks into 4 positions 90deg apart) once

located tighten up the lock nut with the supplied

spanner.

FIG.8

FIG.9

FIG.10

- 13 -