Draper D20NS1700 Руководство пользователя - Страница 13
Просмотреть онлайн или скачать pdf Руководство пользователя для Электроинструмент Draper D20NS1700. Draper D20NS1700 20 страниц. 20v brushless nibbler. d20 multi-tool battery system
Печатать страницу
8. PREPARING THE NIBBLER
To install a cutter head, the cutter needs to be
located in the plunger first, then slide the correct
cutter head over the cutter and locate in the tool, this
may be tricky at first as the cutter needs to line up
accurately to locate the cutter head, it may be easier
to allow the cutter to hang from the plunger (Fig.8.)
and slide the cutter head into place from underneath
with the rapid cutter you may need to slacken the
bolts holding the upper guide on to allow it to slide
easily into place (Fig.10.). You also need to line up
the groove in the cutter with the rear of the cutter
head (Figs.9-10). Don't tighten the bolts up too much
or you may restrict the removal of the cutter head.
Once the cutter head is fully located rotate the head
until it locks into position (the freehand head locks in
two positions 180deg apart and the rapid nibbler
head locks into 4 positions 90deg apart) once
located tighten up the lock nut with the supplied
spanner.
FIG.8
FIG.9
FIG.10
- 13 -