Draper FlexShade Instructions Installation & Operation - Page 3

Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade. Draper FlexShade 4 pages. Exterior clutch-operated shade
Also for Draper FlexShade: Installation & Operation Manual (8 pages), Installation Instructions (2 pages), Instructions Manual (12 pages), Installation & Operation Instructions (11 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (16 pages), Instructions Manual (7 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (16 pages)

Print Page
Draper FlexShade Instructions Installation & Operation
Cordless FlexShade
Section 1 - Installing Brackets
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
Installing Inside Mount Brackets
Section 2 - Inserting Shade Into Brackets
Installing Inside Mount
1. Insert the rail into the front of the bracket.
2. Rotate shade until the back side of shade snaps into the back
of the bracket.
Push Tab
Installing Outside Mount:
1. Insert the rail into the bottom of the bracket.
2. Rotate shade until back side snaps into the back
of the bracket.
Push Tab
®
1. Attach brackets to the top of the
window frame
as shown.
(or ceiling)
2. Install outermost brackets
approximately 2"
in from
(51mm)
the edge of the window frame.
Evenly space any remaining
brackets in between the
outermost brackets.
3. Before drilling the screw in and
securely tightening the bracket
to the mounting surface, ensure
that the plastic tab on the bracket
is facing toward the back of the
window.
Installing Outside Mount Brackets:
Section 3 - Removing Shade from Brackets
CAUTION: Before attempting, hold shade securely to prevent falling.
Removing Inside Mount
1. Press the tab of the bracket in, either with fingers or
a flat head screwdriver.
2. Rotate shade in
(toward the room)
from the bracket.
Push Tab
Removing Outside Mount:
1. Press the tab of the bracket down, either with fingers
or a flat head screwdriver.
2. Once the tab has been pressed down, rotate shade down
until fully removed from the bracket.
Push Tab
page 3 of 4
1. Attach brackets above the
window frame as shown.
2. Install outermost brackets
approximately 2"
in from
(51mm)
the edge of the window frame.
Evenly space any remaining
brackets in between the
outermost brackets.
3. Before drilling the screw in and
securely tightening the bracket
to the mounting surface, ensure
that the plastic tab on the
bracket is facing upward, toward
the ceiling.
until fully removed