Draper FlexShade Talimatlar Kurulum ve Çalıştırma - Sayfa 3

İç Mekan Mobilyaları Draper FlexShade için çevrimiçi göz atın veya pdf Talimatlar Kurulum ve Çalıştırma indirin. Draper FlexShade 4 sayfaları. Exterior clutch-operated shade
Ayrıca Draper FlexShade için: Kurulum ve Kullanım Kılavuzu (8 sayfalar), Kurulum Talimatları (2 sayfalar), Talimatlar Kılavuzu (12 sayfalar), Kurulum ve Çalıştırma Talimatları (11 sayfalar), Talimatlar Kurulum ve Çalıştırma (12 sayfalar), Talimatlar Kurulum ve Çalıştırma (16 sayfalar), Talimatlar Kılavuzu (7 sayfalar), Talimatlar Kurulum ve Çalıştırma (12 sayfalar), Talimatlar Kurulum ve Çalıştırma (16 sayfalar)

Sayfayı Yazdır

Draper FlexShade Talimatlar Kurulum ve Çalıştırma

Cordless FlexShade

Section 1 - Installing Brackets

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

Installing Inside Mount Brackets

Section 2 - Inserting Shade Into Brackets

Installing Inside Mount

1. Insert the rail into the front of the bracket.

2. Rotate shade until the back side of shade snaps into the back

of the bracket.

Push Tab

Installing Outside Mount:

1. Insert the rail into the bottom of the bracket.

2. Rotate shade until back side snaps into the back

of the bracket.

Push Tab

1. Attach brackets to the top of the

window frame

as shown.

(or ceiling)

2. Install outermost brackets

approximately 2"

in from

(51mm)

the edge of the window frame.

Evenly space any remaining

brackets in between the

outermost brackets.

3. Before drilling the screw in and

securely tightening the bracket

to the mounting surface, ensure

that the plastic tab on the bracket

is facing toward the back of the

window.

Installing Outside Mount Brackets:

Section 3 - Removing Shade from Brackets

CAUTION: Before attempting, hold shade securely to prevent falling.

Removing Inside Mount

1. Press the tab of the bracket in, either with fingers or

a flat head screwdriver.

2. Rotate shade in

(toward the room)

from the bracket.

Push Tab

Removing Outside Mount:

1. Press the tab of the bracket down, either with fingers

or a flat head screwdriver.

2. Once the tab has been pressed down, rotate shade down

until fully removed from the bracket.

Push Tab

page 3 of 4

1. Attach brackets above the

window frame as shown.

2. Install outermost brackets

approximately 2"

in from

(51mm)

the edge of the window frame.

Evenly space any remaining

brackets in between the

outermost brackets.

3. Before drilling the screw in and

securely tightening the bracket

to the mounting surface, ensure

that the plastic tab on the

bracket is facing upward, toward

the ceiling.

until fully removed