Electrolux Clarus Vibe WH6-14LAG Installation Manual - Page 14

Browse online or download pdf Installation Manual for Washer Electrolux Clarus Vibe WH6-14LAG. Electrolux Clarus Vibe WH6-14LAG 32 pages. Washer extractor

Print Page
14

4.4 Mechanical installation

If the machine is not to be mounted on a base the machine must be fastened to the floor with the enclosed expansion
bolts.
The table shows the correct position of feet and drilling points.
Mark and drill two holes (⌀ 10 mm) about 50 mm deep in position (1).
C
D
G
F
mm
A
635
Place the machine over the two drilled holes. The holes are at the front of the machine.
Level the machine with the feet of the machine. Screw in the feet as much as possible before starting to level the ma-
chine. This will make the machine stand steadier.
The maximum height adjustment of the feet is 50 mm.
Insert the expansion bolts (1) into the holes drilled in the floor. Fit the washers and nuts and tighten with tightening
torque 5 Nm.
It is of the upmost importance that the machine is placed in level, from side to side as well as front to rear.
Remount the panels when ready.
Installation manual
A
1
X
X
E
B
C
490
135
B
H
D
E
175
515
X-X
1
F
G
195
65
fig.5989C
H
125