Carlisle Fluid Technologies TC-IR3S-03 Service Manual - Page 6

Browse online or download pdf Service Manual for Service Equipment Carlisle Fluid Technologies TC-IR3S-03. Carlisle Fluid Technologies TC-IR3S-03 11 pages.

Print Page

IR3S – OPERATIONS

Turn the main switch on. This will initiate the electronics.

Four dots will sequentially blink to indicate the start-up.

Next the top display will show 1P (1-phase). The lower

display shows the supply frequency 50 or 60 Hz.

When the start-up sequence is over, the displays show

the active curing times in minutes. Flash-off at the upper

and full bake at the lower.

Use the + and - buttons below the displays to change

the settings. Pressing the buttons continuously will

rapidly increase the setting. Each timer can be set

between 0 and 30 min. The settings will remain even

after power-off and serve as default for the next curing

operation.

Start the curing by pressing the On/Off button. The

active timer will flash and the heater will switch off

automatically when the set times have elapsed.

After idling for 30 minutes, the unit enters stand-by

mode when a dot in each display flashes. Pressing any

button will activate the unit again.

www.carlisleft.com

TRU CURE IR3S – OPERATING INSTRUCTIONS

FLASH OFF TIMER

FLASH OFF SETTINGS

FULL BAKE TIMER

FULL BAKE SETTINGS

ON/OFF BUTTON

MAIN SWITCH – LOCATED ON THE

RIGHT HAND SIDE

Minimum curing distance is 50 cm and optimal curing

distance is 60 cm.

The FLASH OFF timer controls the duration of the half

power output of the emitters. The FULL BAKE timer

controls the duration of the full power output of the

emitters. If both FLASH OFF and FULL BAKE timers

are used, the FLASH OFF timer will count down first

and upon switching off it will engage the FULL BAKE

timer automatically.

To stop the unit before the time is out, press the On/

Off button.

Altering timers is possible even during curing.

If the temperature inside the control unit rises over

65°C (149°F) , the unit switches off. The upper

display will show Ot (over temperature) and the

lower the actual temperature. Automatic reset when

the temperature falls below 55°C (131°F) and the

unit is ready for operation again.

6 / 11

White RAL 7016

Yellow RAL 1021

Yellow RAL 2004

White RAL 9016

Transparent

OVERLAY Trisk IR without pyrometer

NOTES

2022-06-03

SB-81-014-R1 (3/2023)