Bosch Vision 800 Series Service Manual - Page 20

Browse online or download pdf Service Manual for Oven Bosch Vision 800 Series. Bosch Vision 800 Series 36 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Service Manual (43 pages), Installation Instructions Manual (28 pages)

Print Page

58300000194725 ARA EN B

3. Position the new display board so that the slots in the board

align with the four metal tabs, and firmly push the board

downward until it is securely in place.

4. Slightly re-twist each of the four metal tabs.

5. Reassemble the control panel.

6. Reattach the control panel to the range.

7. Restore power and test operation.

6.4

Cavity Light

Each oven cavity uses one incandescent 40W appliance bulb with a

standard Edison base (E26). Replacement bulbs may be purchased

locally.

The cavity light can be turned on in two ways: by pressing Oven Light

or opening the oven door. If Oven Light had not been pressed to turn

light on prior to opening the oven door, the light will turn off when the

door is closed. If Oven Light had been pressed to turn light on prior to

opening the oven door, the light will remain on after the door is closed.

In other words, the Oven Light switch overrides the door.

6.4.1

Replacing the Lamp

CAUTION

 Turn off power to the range at the fuse or breaker box: light

socket is live with door open.

 Be sure oven and lights are cool to the touch.

 Handle glass lenses and glass bulbs carefully.



NOTICE

Sometimes, after running a self-clean cycle at high heat, it may become

difficult to remove the glass lens. If it cannot be done by hand, an

adjustable strap-wrench may be used.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

MAY 2016

1. Unscrew glass lens cover by turning it counter-clockwise.

Figure 24 Removing the glass lens

2. Unscrew the appliance bulb by turning it counter-clockwise.

3. Insert the new bulb.

4. Replace the glass cover.

5. Restore power to the unit and test the operation of the light.

6.5

All 800 series gas slide-in ranges have a convection fan on the rear

cavity wall.

Depending on the cooking mode selected, the fan may be used to

circulate heat evenly throughout the cavity.

The fan blade is easily accessed on the rear wall of the oven cavity

behind the convection baffle. Replacing the convection fan motor will

require access to the rear of the unit.

6.5.1 Replacing the Convection Fan Blade

1. Remove power to the range.

2. Remove the screws securing the convection baffle to the rear

wall of the oven cavity.

3. While holding the fan blade, loosen the nut by turning it

clockwise; set the nut and washer aside.

4. Remove the fan blade from the shaft of the motor, noting that

there is a second washer behind the fan blade.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 800 Series Gas Slide-in Ranges

Convection Fan and Motor

Page 20 of 36

800 944-2904