Bosch Vision 800 Series Service Manual - Page 19

Browse online or download pdf Service Manual for Oven Bosch Vision 800 Series. Bosch Vision 800 Series 36 pages. Gas slide-in ranges
Also for Bosch Vision 800 Series: Instructions For Use Manual (40 pages), Dimensions And Specifications (2 pages), Installation Manual (6 pages), Service Manual (43 pages), Installation Instructions Manual (28 pages)

Print Page

58300000194725 ARA EN B

Also attached to the front panel assembly are the display board and

its sheet metal carrier. These parts are not actually included with the

front panel service assembly; the display must be ordered separately.

Front Panel Test is available in Service mode. See the Service Mode

section for details.

6.3.1 Replacing the Control Panel Assembly

1. Remove power to the range.

2. Protect the top of the oven door to prevent damage to the front

panel or door.

3. Remove two screws on the underside of the panel assembly –

one on the right and one on the left – which secure the panel

to the vent trim.

4. Remove one screw on each side of the control panel

assembly.

Figure 21 Location of screws on control panel service assembly

5. Grasping the panel by both sides, carefully pull it forward; the

user interface harness connected to the TCM and to the

display will limit how far away the control panel assembly can

be moved initially.

6. Disconnect the user interface harness from the TCM and the

display board.

7. Remove the four screws securing the sheet metal carrier to

the control panel assembly and set the carrier and display

board aside.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

MAY 2016

Figure 22 Location of screws on sheet metal carrier

8. Install the carrier and display board to the new control panel

service assembly using the four screws removed in step 7.

9. Re-connect the user interface harness, then install the new

control panel assembly.

10. Restore power and test operation.

6.3.2 Replacing the Display Module

The display module is secured to the sheet metal carrier with

four metal tabs.

Figure 23 Display board secured to carrier with the carrier's 4 metal tabs

1. Remove the control panel as described in Replacing the

Control Panel Assembly section.

2. Using pliers, gently straighten each metal tab so that they align

with the slots in the display board, then lift the board off the

tabs.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch 800 Series Gas Slide-in Ranges

Page 19 of 36

800 944-2904