Anchor bigfoot Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Speakers Anchor bigfoot. Anchor bigfoot 13 pages. Line array sound system
Also for Anchor bigfoot: Quick Start Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages)

Print Page

Bigfoot® Sound System Owners Manual

BATTERY REPLACEMENT

The batteries must be replaced every 2 – 3 years depending on usage

over time. Call Anchor Audio at 800.262.4671 to order batteries or

order them online at anchoraudioparts.com.

To replace your batteries you will need a Phillips screwdriver and to

follow these procedures:

NOTE: Proper operation of this product requires three (3) 12V batteries

connected in series.

1. Be sure the POWER is in the OFF

2. Remove wingnut from battery retainer bolt.

3. Swing battery retainer bracket away from terminals to free

the nearest battery.

CAUTION: DO NOT ALLOW BRACKET TO CONTACT

BATTERY TERMINALS

4. Disconnect wires from positive (red) and negative

(black) terminals.

5. Lift battery from tray and pull battery through opening to

remove.

6. For remaining two batteries, pull each forward in tray and

repeat steps 3-4, taking note of which wire connects to each

battery terminal.

7. Install new batteries one-at-a-time (reverse sequence from

removal) and slide each under the retainer bracket. Take care

to connect the proper wires to each battery terminal.

8. Reposition retainer bracket onto retainer bolt and fit wingnut

onto bolt to firmly secure bracket into place.

SYSTEM STORAGE & BATTERIES

Fully charge batteries before storage. For extended periods of

storage, charge the system at least once each month for a minimum

of 24 hours.

For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com

BUILT-IN BATTERY MAINTENANCE

To preserve battery life, the built-in batteries MUST be FULLY

charged before the first use. Regardless of length of operation,

it is recommended that batteries be fully charged as soon as

possible after each use.

AC OPERATION & BATTERY CHARGING

Bigfoot Sound Systems include an automatic charging system

designed to properly charge and maintain the system's built-in

batteries. To charge batteries, plug the system into an AC outlet.

The BATTERY LEVEL INDICATOR will light when charging. The

CHARGE STATUS led will light bright red which indicates charge

process has begun and green indicates full battery. It takes

approximately 8 hours to charge the completely drained Bigfoot

batteries.

BATTERY SERVICE TIME

Fully charged batteries will yield approximately 6 – 8 hours of

continuous music at medium volume level (2 – 4 hours at full

volume or longer for speech only) . However, service times vary

depending on control settings and use of accessories.

BATTERY COMPARTMENT

NOTE: System Can Be Used During Charging!

Waste electrical and electronic products must

not be disposed of with household waste. Please

recycle where facilities exist. Check with your

Local Authority or Retailer for recycling advice.

MADE IN USA

SIX YEAR WARRANTY