Anchor Cinemark Owner's Manual - Page 5

Browse online or download pdf Owner's Manual for Stereo System Anchor Cinemark. Anchor Cinemark 8 pages.

Print Page

Cinemark Acclaim Lectern Sound System Owners Manual

CARING FOR YOUR BUILT-IN BATTERY

It is very important that you fully charge the battery in your new

portable lectern before the first time its used. To preserve battery

life it is also recommended that the battery be fully charged

as soon as possible after every use regardless of the length of

operation.

UNDERSTANDING THE BATTERY LEVEL INDICATOR

LED Flashing Red: Battery charge is very low, in 15-30 minutes

the Battery Protection Circuit will turn the system off.

LED Off: Battery is completely drained and must be charged.

NOTE: System can be used while battery charges!

OPERATING IN AC MODE

Plug the charger cable located inside the BASE to the back panel.

Operate as normal while charging the built-in battery at the same

time. The Charger LED will light during charging and flash when

the battery is fully charged.

BATTERY SERVICE TIME

With the battery is fully charged you can expect approx.:

8-12 hrs @ Medium Volume 3-6 hrs @ Full Volume

of continuous music input (longer for speech). Service time will

vary depending on control settings and use of accessories

(built-in wireless receivers and/or a companion speaker).

IMPORTANT

: For longer battery life always store your system

with battery fully charged!

Waste electrical and electronic products must not be disposed

of with household waste. Please recycle where facilities exist.

Check with your Local Authority or Retailer for recycling advice.

For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com/cinemark/

CHARGING YOUR BUILT-IN BATTERIES

An automatic charging system is built-in to your Acclaim

Portable Lectern. It is designed to properly charge and

maintain the systems built-in battery. To charge battery:

1. Plug the charger cable located inside the BASE to

the back panel

2. Battery fully charges in approximatly

6-8 hrs - Charger LED will flash

When in AC mode the system automatically transfers

power from the battery charger to the power amplifier at

high volume output, causing the Charger LED to flicker.

SYSTEM STORAGE & BATTERIES

Always store your sound system with the battery fully

charged, or if preferred, charge while being stored. For

extended periods of storage leave the system plugged into

an AC outlet. If this is not possible, charge the system at

least once each month for a minimum of 24 hours.

NOTE: System Can Be Used During Charging!

MADE IN USA

SIX YEAR WARRANTY