Anchor Cinemark Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Стереосистема Anchor Cinemark. Anchor Cinemark 8 сторінок.
Друкувати сторінкуCinemark Acclaim Lectern Sound System Owners Manual
CARING FOR YOUR BUILT-IN BATTERY
It is very important that you fully charge the battery in your new
portable lectern before the first time its used. To preserve battery
life it is also recommended that the battery be fully charged
as soon as possible after every use regardless of the length of
operation.
UNDERSTANDING THE BATTERY LEVEL INDICATOR
LED Flashing Red: Battery charge is very low, in 15-30 minutes
the Battery Protection Circuit will turn the system off.
LED Off: Battery is completely drained and must be charged.
NOTE: System can be used while battery charges!
OPERATING IN AC MODE
Plug the charger cable located inside the BASE to the back panel.
Operate as normal while charging the built-in battery at the same
time. The Charger LED will light during charging and flash when
the battery is fully charged.
BATTERY SERVICE TIME
With the battery is fully charged you can expect approx.:
8-12 hrs @ Medium Volume 3-6 hrs @ Full Volume
of continuous music input (longer for speech). Service time will
vary depending on control settings and use of accessories
(built-in wireless receivers and/or a companion speaker).
IMPORTANT
: For longer battery life always store your system
with battery fully charged!
Waste electrical and electronic products must not be disposed
of with household waste. Please recycle where facilities exist.
Check with your Local Authority or Retailer for recycling advice.
For System Setup & Operation Videos Visit Our Website: www.anchoraudio.com/cinemark/
CHARGING YOUR BUILT-IN BATTERIES
An automatic charging system is built-in to your Acclaim
Portable Lectern. It is designed to properly charge and
maintain the systems built-in battery. To charge battery:
1. Plug the charger cable located inside the BASE to
the back panel
2. Battery fully charges in approximatly
6-8 hrs - Charger LED will flash
When in AC mode the system automatically transfers
power from the battery charger to the power amplifier at
high volume output, causing the Charger LED to flicker.
SYSTEM STORAGE & BATTERIES
Always store your sound system with the battery fully
charged, or if preferred, charge while being stored. For
extended periods of storage leave the system plugged into
an AC outlet. If this is not possible, charge the system at
least once each month for a minimum of 24 hours.
NOTE: System Can Be Used During Charging!
MADE IN USA
SIX YEAR WARRANTY
5