Common Sense RC SNAP&FLY Owner's Manual - Page 15

Browse online or download pdf Owner's Manual for Toy Common Sense RC SNAP&FLY. Common Sense RC SNAP&FLY 17 pages. 3-in-1 rtf modular airplane system

Print Page

1) Align the LiPo battery's magnetic connectors with the matching magnetic connectors

of the charger, and connect the battery to the charger, as shown in Photo 5A;

2) Repeat 1) for the second battery at the second charging position if needed;

3) Close the charger cover;

4) Switch the "On-Charge-Off" 3-position switch to the "Charge" position. The charger

LED(s) will turn on, indicating that charging is in progress; Depending on the degree

of the battery depletion, the charging time may be up to 40 to 60 min.

5) When charging is complete the Charger LED dims. At this point turn the 3-positon

switch to "Off", open the charger cover and remove the fully charged battery.

A dim, blinking Charger LED indicates no-battery-connected. If the LED is still blinking

after a battery is connected for charging, consider the following possibilities:

1) Dirty connector(s) – clean the connectors;

2) Broken battery lids – replace the battery;

3) Bad LiPo battery – replace the battery;

B. Replacing the Propeller

Remove the old propeller by carefully and progressively prying it loose using a pair of

tweezers against the motor mount. Use small (less than 5 degree) prying motions each

time as shown in Photo 5B.

To install a new propeller:

1) Use light pressure to insert the motor shaft tip into the propeller center hole; (The

shinier propeller blade surface should face the motor)

2) Place the end of the propeller hub against a hard surface, and gently push the motor

retaining lever of the motor mount toward the propeller hub to further insert the motor

shaft into the propeller center hole until the shaft tip reaches the end of the hole.

SNAP&FLY -- Modularized RC Airplanes

Photo 5A – charging the LiPo batteries

Photo 5B – replacing propeller