Andel FilterSepta 2 Installation And Operation Manual - Page 3

Browse online or download pdf Installation And Operation Manual for Water Filtration Systems Andel FilterSepta 2. Andel FilterSepta 2 9 pages.

Print Page

Introduction

Andel Filtersepta 2 performs to the requirements of a Class 1 full retention oil/water
separator and relevant sections of EN858-1:2002 – less than 5ppm hydrocarbons in water
discharged, under test conditions. The Filtersepta 2 is designed to work in conjunction with
a BundGuard unit to remove any small traces of oil, which may be present in the discharge
from the BundGuard ("Yes to water! – No to oil!" pumping system, less than 5ppm under
test conditions).
The system is fitted with 2 sensors one for excess oil detection and one for high level
detection, in the event of either sensor been active the BundGuard unit will stop pumping
automatically, the system will also stop if the lid to the unit is opened.
If the attached BundGuard unit stops pumping for a period, due to activation on the
FilterSepta sensors the level in the pump's sump will build up and a high-level alarm will be
generated by the BundGuard control panel.
The general arrangement of the Filtersepta 2 is show in the diagram below:
3
Filtersepta 2 28.01.2022 Rev.0