ATI Technologies Scorpion X2 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Measuring Instruments ATI Technologies Scorpion X2. ATI Technologies Scorpion X2 2 pages.

Print Page

Step #4

With the template secured to the buttstock, use a

1/4" drill bit to drill 2 straight holes on each side of

the buttstock. Use the designated "X" in circles on

the template as markers for these 2 holes.

NOTE: ATI is NOT responsible for broken drill bits

Figure 4

Step #5

Using the circle on the template and the same 1/4"

drill bit, drill the single hole on the bottom of the

buttstock 1/8" deep.

NOTE: This hole will not be drilled through, you

must only drill 1/8" into the buttstock. The best

way to drill 1/8" is to measure 1/8" from the edge

of the drill bit and then place tape at the 1/8"

mark so you don't drill any deeper.

Figure 5A

-Installation Instructions-

Thank you for purchasing an ATI product!

Buttpad Installation

1/8"

Figure 5B

Scorpion X2 Pad

Part # A.5.10.1015

Step #6

Remove the buttpad template and clean the

buttstock of any burrs and drilling material.

Step #7

Place the buttpad on the rear of the buttstock and

using a T-20 torx driver, install the (2) 8 x 48-2 x 1/2"

plastite torx head screws until snug.

Figure 6

Figure 7

Page 2