Caroma G Series Installation And Maintenance Instructions Manual - Page 12

Browse online or download pdf Installation And Maintenance Instructions Manual for Plumbing Product Caroma G Series. Caroma G Series 16 pages. Electronic soap dispenser
Also for Caroma G Series: Installation And Maintenance Instructions Manual (16 pages), Installation And Maintenance Manual (16 pages), Installation And Maintenance Manual (17 pages)

Print Page

sETTINGs ADjusTMENT

adjusting the sensor range without a remote control:

1. disconnect the power supply, battery or transformer, from the sensor.

2. activate the sensor three or four times.

3. Reconnect the power supply to the sensor.

4. to enter into the adjusting mode, put your hand in front of the sensor at a

distance of 2"(5cm) to 4"(10cm) within 5 seconds after the reconnection of the

power supply.

note: If you will not put your hand in front of the sensor after connecting the

power supply, the sensor will not enter into adjusting mode and the previous

setting will return.

5. When the sensor enters into the adjusting mode and your hand is in front of

the sensor, a slow flashing of the red light at the front of the sensor will occur.

6. Keep your hand at the front of the sensor until the slow flashing changes into

quick flashing. at this

point, move your hand

to the required distance

from the sensor and

wait until the red light

will stop flashing.

7. When the red light

has turned off, the

sensor

has

adjusted to the required

distance.

8. check the distance

you have set and if it is

not satisfactory, repeat

steps 1-6.

Mains option

been

Battery option