Andon KD-322 Operation Manual - Page 7
Browse online or download pdf Operation Manual for Blood Pressure Monitor Andon KD-322. Andon KD-322 14 pages. Semi automatic arm cuff blood pressure monitor
Print PageDN:KD-322-SMSY01 V4.0
Please refer to the cuff circumference range in "SPECIFICATIONS" to make
1.
sure that the appropriate cuff is used.
2.
Measuring on same arm each time.
3.
Do not move your arm, body, or the monitor and do not move the rubber tube
during measurement.
4.
Stay quiet, calm for 5 minutes before blood pressure measurement.
5.
Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor
and clear it by hand in a mild detergent, then rinse it thoroughly in cold water.
Never dry the cuff in clothes dryer or iron it. Clean the cuff after the usage of
every 200 times is recommended.
4. BODY POSTURE DURING MEASUREMENT
Sitting Comfortably Measurement
a. Be seated with your feet flat on the floor, and don't cross
your legs.
b. Place palm upside in front of you on a flat surface such as
a desk or table
c.
The middle of the cuff should be at the level of the right atrium of
the heart.
5. TAKING YOUR BLOOD PRESSURE READING
a.
After applying the cuff and your body is in a comfortable position, press the
"ON/OFF" button. A beep is heard and all display characters are shown for
self-test.
b. After that, LCD will show "0" mmHg that indicate you can begin to inflate.
c. Please squeeze the bulb till the pressure is over your normal systolic pressure by
30mmHg, if you don't know your normal systolic pressure, please squeeze the
bulb till the pressure to 190mmHg.
d. Then the monitor slowly releases air from the cuff and carries out the
measurement. Finally the blood pressure and pulse rate will be calculated and
displayed on the LCD screen.
7/14
Operation Guide
Template version:1