Dremel 3D20 Idea Builder Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for 3D Printers Dremel 3D20 Idea Builder. Dremel 3D20 Idea Builder 2 pages. Unclogging
Also for Dremel 3D20 Idea Builder: Quick Start Manual (8 pages), Quick Start Manual (2 pages), Quick Start Manual (8 pages), Quick Start Manual (4 pages), Quick Start Manual (4 pages), Troubleshooting Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages), Quick Start Manual (2 pages)

Print Page
Dremel 3D20 Idea Builder Quick Start Manual
Step 4: Move, by hand, the extruder to
the center of the Idea Builder.
Step 5: Open the front door, then using
the allen wrench, loosen the two screws
on the front fan.
Step 6: Remove the fan exposing the
drive gear.
Step 7: Remove the clogged filament
with a needle nose pliers. Note: Make
sure to remove all remnants of the
clogged filament and discard
appropriately. Any remaining filament
may cause the printer to not work
properly.
Step 8: Replace the stepper motor
and fan. Tighten the 2 fan screws in
place. Note: Screws should be hand
tightened. Do not over tighten or you
may damage the extruder fan.
2