Dremel 3D20 Idea Builder Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dremel 3D20 Idea Builder. Dremel 3D20 Idea Builder 2 pagina's. Unclogging
Ook voor Dremel 3D20 Idea Builder: Snelstarthandleiding (8 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (8 pagina's), Snelstarthandleiding (4 pagina's), Snelstarthandleiding (4 pagina's), Handleiding voor probleemoplossing (2 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (2 pagina's)

Step 4: Move, by hand, the extruder to

the center of the Idea Builder.

Step 5: Open the front door, then using

the allen wrench, loosen the two screws

on the front fan.

Step 6: Remove the fan exposing the

drive gear.

Step 7: Remove the clogged filament

with a needle nose pliers. Note: Make

sure to remove all remnants of the

clogged filament and discard

appropriately. Any remaining filament

may cause the printer to not work

properly.

Step 8: Replace the stepper motor

and fan. Tighten the 2 fan screws in

place. Note: Screws should be hand

tightened. Do not over tighten or you

may damage the extruder fan.