Andonstar AD407 User Manual - Page 9

Browse online or download pdf User Manual for Microscope Andonstar AD407. Andonstar AD407 14 pages.
Also for Andonstar AD407: User Manual (11 pages)

Print Page

(P6 connect )

Quick start

Connect

To use the microscope stand alone, you need to connect the optical stack to the power supply via the

switch cable. See the picture(P6) above.

Switch on

Then press and hold the Power button (① from the P4 "Buttons") underneath the display until the

display turns on. (It may turn on automatically while you connecting cables at the first time, and it's

totally fine.)

*Troubleshooting

If the display freezes, locate the "reset " hole on the back of the monitor. Use a narrow object such as an

unfolded paperclip to depress the button located inside. This resets all settings to their factory values and

restarts the display. It does not erase saved images or video.

① Use the large knobs on the optical bracket to raise or lower the optical stack to the desired height. The

lower the height, the greater the magnification is. But be careful not to let the bottom of the stack contact

the object being imaged. (Note that you may need to reposition the spotlights as you move the stack up

or down.)Turn the Focus controller( ⑧ from the P4 "Buttons") to focus the image.

② To increase the digital magnification, press and hold the Up button (③ from the P4 "Buttons" ) until

the desired digital magnification(up to an additional 3x beyond the optical magnification) is reached.

Use the Down (number ④ from the picture "Buttons") button to decrease the digital magnification.

By using a Micro SD card (not provided), you can save images and videos to review later or export to a

computer or other device .

Insert the Micro SD card in to the TF slot on top back of the monitor. (be careful with the direction. The

side which has metal exposed, should face down. See the picture 6 )

Push it in until you hear a click. (If you don't push it in far enough, it will be ejected.)

*If you insert the card while the microscope's working, the device would switch off automatically. Press

the Power button and hold it until the screen lights up again.

The Mode button(number ② from the picture "Buttons", marked with an "M") can be used to cycle

between three modes: video standby ( ), still image ( ), and review ( ). In video standby mode, there

are white color numbers located right to the icon, shows how many time the rest storage of the card

would allow you to record video.

To record videos