Electrolux EFC 6420 User Manual - Page 12

Browse online or download pdf User Manual for Ventilation Hood Electrolux EFC 6420. Electrolux EFC 6420 15 pages. Electrolux cooker hood
Also for Electrolux EFC 6420: User Manual (15 pages), User Manual (15 pages), User Manual (15 pages)

Print Page

Installation

Wall unit mounting - Fig. 9

Disconnect the hood during electrical connection, by turning the home mains switch off.

• Rest the suction unit on a flat surface and thread the lower part of the hood onto it (1).

• Make all the electrical connections between the two parts (2).

• Fasten the hood to the suction unit using 8 screws (3).

• Sign the wall with a center line, this will aid mounting procedure (4), position the template so that the mid line

printed on the template matches with the center line previously signed, the lower side of the template

corresponds to the lower side of the hood once mounted (5).

• Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (6).

• Hang the hood (7) adjust its position (8-9) and from the inside of the hood sign one point for definitive fixing

(10), remove the hood (11) and drill an hole Ø 8mm (12), fit a wall plugs (13).

• Drill two holes Ø 8mm on the upper side

close to the ceilling (14), fit two wall

plugs and fix the chimney support

with two screws (15).

• Hang the hood again

(16).

• Fix it definitively with a

screw (17). To

simplify the mounting

operation remove the

carbon filter frame.

• In case the hood is to

be used in filter

version, mount the

deflector F on the

chimney support G

with four screws

2,9x6,5 and fit an

exhausting pipe (18) to

connect deflector to the

outlet hole D of the hood.

In case the hood is to be used

in exhausting version, then the

deflector must not be

mounted and fit an exhausting

pipe (18) to connect outlet

hole D of the hood to the

outside.

• Make electrical

connection (13), but

leave the hood

disconnected from the

home general electric

panel.

• Fix the chimney (16a)

to the chimney support

(16b).

Slide down the lower section on

the proper housing on top of the hood.

Connect the hood the the home general electric

panel and check if the hood work properly.

Fig. 9