Electrolux WRH908I Series User Manual - Page 7

Browse online or download pdf User Manual for Ventilation Hood Electrolux WRH908I Series. Electrolux WRH908I Series 12 pages. Retractable
Also for Electrolux WRH908I Series: Operation Manual/Installation Instructions (12 pages), Operation Manual & Installation Manual (12 pages)

Print Page

OPERATION

IMPORTANT!

The Edison Screw lamps may have come loose

during transportation.

Ensure that lamps are tightened firmly into the

socket before power is applied.

REHR6*

The operation of the light and the two-speed fan are

controlled by the drawer action. (see diagram)

WRH605I* WRH608I* WRR614*A WRH908I*

The operation of the lights and the three speed fans

are controlled by the drawer action. (see diagram)

Fan speed

3 speed

models

2 speed

models

To replace the light globes

1. Open drawer and remove filter.

2. Turn mains switch off before removing lamp.

Replace with 28W maximum E14 halogen candle lamp.

Depending on model will require 1 or 2 globes. The lamp

assembly includes a silicone seal, this must be replaced

when a new lamp is used. The silicone seal is placed over

the lamp thread and then the lamp is screwed into the

holder. Ensure replacement lamp is tightened firmly.

Replacement lamps from Electrolux Parts Centres are

supplied with silicone seals.

Maintenance

To maintain efficiency and reduce fi re risk, fi lters should

be removed every four weeks (maximum) for cleaning.

Soak and agitate filters in hot soapy water or washing

soda. Rinse, drain, shake well and replace.

Do not use caustic solutions or other corrosive agents.

The filters can be washed in the dishwasher,

recommended the filters be placed on the top shelf of

the dishwasher.

NOTE: Where fitted, optional carbon filters are intended

to be a disposable item and should be discarded

when saturated. Washing the carbon filter is not

recommended.

Remove filters for cleaning

1. Slide filter tray forward 1cm.

2. Push in clip on either side to release fi lter. Fig 1.

3. Pull filter downwards to remove. Repeat 2 & 3 for

models with a second fi lter. Fig 2.

4. Turn off mains switch before cleaning drawer and

rangehood body.

5. After cleaning, re-fit filters making sure the clip pins

are securely fitted into the locating holes in the

rangehood body and for twin filter versions, also

located in the pull out drawer section.

6. Holding clip in, push opposite side of filter up until pins

are over locating holes.

7. Release clip ensuring fi lter is securely fitted.

Safety Tips: Use of two hands for removal and re-fitting

of filters is recommended to avoid accidental dropping

of filters which could cause damage to your cooktop or

kitchen surfaces.

Press

Fig. 1

Fig. 2