Advanced Radiant Systems CS5-16-VD-TB Operation And Maintenance Manual - Page 6

Browse online or download pdf Operation And Maintenance Manual for Freezer Advanced Radiant Systems CS5-16-VD-TB. Advanced Radiant Systems CS5-16-VD-TB 16 pages. Cool-space, glacier tall base

Print Page

4.0 Operating procedures

There are 3 factors to consider when determining where to place the COOL-SPACE

1. Fresh air supply: The inlet side of the unit (pad side) requires a constant,

uninterrupted supply of fresh air for maximum performance. A distance of 3 feet

clear space to any obstructions at the rear or inlet side of the unit is

recommended.

2. Discharge air flow: The cool air discharged from the unit should be free of

obstruction to allow the air to circulate in order to maximize the cooling zone.

3. Ventilation: In order to operate at maximum effectiveness, it is helpful to have

provisions to remove the air discharged from the COOL-SPACE

cooling area. This ensures that the COOL-SPACE

has already been through the evaporative cooling process.

The COOL-SPACE

unit must be placed on a level surface to operate correctly. Units create

an oval shaped air pattern. Obstacles such as racks and workbenches may interfere with the

air flow. An attempt should be made to locate the unit in such a manner that interruption of the

air pattern is held to a minimum. Multiple units may be required to cover larger areas.

When the COOL-SPACE

recommended that there be a space of at least 3 feet between the back (pad side) of the unit

and the obstruction. This ensures that a clear supply of fresh air is able to get to the inlet of the

unit.

4.1 Filling the unit with water

Once the COOL-SPACE

the water supply valve on and the unit will fill with water. The float valve will shut off the water

flow when the sump is full.

4.2 Starting the fan

Turn the fan switch to HIGH speed on start-up, allow motor to reach maximum speed, and

then adjust to your preferred setting.

unit is placed near a wall or other vertical obstruction, it is

unit has been connected to a water source as described in 3.1, turn

unit from the

unit does not recirculate air that

unit.