ABSCO SHEDS ADGAZEBO63 Manual - Page 10

Browse online or download pdf Manual for Outdoor Furnishing ABSCO SHEDS ADGAZEBO63. ABSCO SHEDS ADGAZEBO63 14 pages. Signature gazebo

Print Page
FRONT & REAR FLASHING
LOW SIDE UNDERSIDE
VIEW
6. Repeat these steps for
the other end flashing. Just
remember
mirrored version.

FRONT EDGE

FRONT FLASHING
TR37
#1
UNDERSIDE VIEW
Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO63
6.12m W x 3.11m D x 2.60m H
to
make
the
FRONT TOP VIEW
TR37
#2
Model: ADGAZEBO63
5. Refit the flashing, and fasten using pop rivets
FAST102 at the locations shown.
Only at the low side, on top, use teks with
neoprene washers FAST101.
HIGH SIDE UNDERSIDE VIEW
To increase weather protection do the following.
A. Turn up pans of sheet 15 degrees using "Sheet
Metal Locking Pliers"
B. Installing foam gaskets RWG28 within 90mm
of the edge.
Some trimming may be required to fit at ends.
Apply silicone to the face that sits in the pan.
1. Starting at the front end of the structure,
take one TR37 flashing and place over the front
flashing and roof panels as shown.
2. Take the second TR37 flashing and place
alongside, butted against the first & trim so it
finishes at the rear flashing.
3. Fasten with pop rivets FAST102 along the
underside are shown.
Fasten with tek screws with neoprene washers
FAST101 along the top.
4/12/23
1.00
10