ABSCO SHEDS SIGNATURE ADGAZEBO33 Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Outdoor Furnishing ABSCO SHEDS SIGNATURE ADGAZEBO33. ABSCO SHEDS SIGNATURE ADGAZEBO33 14 pages.

Print Page

FITTING THE SHURELOCK BEAMS

0. Remove the protective plastic coating from

the outside of the beam.

2. Make sure the ends of the beam are all the

way into the brackets and fasten each end with

four FAST100 tek screws.

These are visible screws so take time to position

them on the centreline of the BK3 bracket and

inset equally from the top and bottom.

3. Repeat these steps for the rear beam before

proceeding to step 4.

On the exterior side of the rear beam only put in

the lower teks for now.

Absco Industries

Assembly Instruction Manual

ABSCO SIGNATURE GAZEBO

MODEL: ADGAZEBO33

3.11m W x 3.11m D x 2.60m H

1. Safely lift and place a SB1 beam inside the

front post brackets BK3 as shown.

Overlap to

NOTE: Beam orientation is important to prevent

water entry.

Orientate the beam so the exterior face has the

overlap to the top.

4. Safely lift and place the side beam SB1 inside

the post brackets BK3 as shown.

5. Make sure the ends of the beam are as far

as they can go into the brackets, there will be a

small gap at the top for the front due to angle.

Fasten each end with four FAST100 tek screws

as before.

6. Repeat these steps for the other side beam

Model: ADGAZEBO33

top

21/09/23

Overlap to

bottom

1.00