ABSCO SHEDS SIGNATURE ADGAZEBO33 Instruction Manual - Page 7
Browse online or download pdf Instruction Manual for Outdoor Furnishing ABSCO SHEDS SIGNATURE ADGAZEBO33. ABSCO SHEDS SIGNATURE ADGAZEBO33 14 pages.
ATTACH REAR FLASHING
1
3
ROOF PANELS
REAR VIEW - Aligning the first panel
Rear beam
6
7
Absco Industries
Assembly Instruction Manual
ABSCO SIGNATURE GAZEBO
MODEL: ADGAZEBO33
3.11m W x 3.11m D x 2.60m H
2
5
Rear flashing
8
1. Place the rear flashing TR35 along the rear
beam as pictured.
Align side shown to be flush with the exterior of
the beam.
2. Overhang the left side of by 130 mm.
3. Fasten flashing to top of beam with 4 evenly
spaced pop rivets FAST102.
A. Check the foam core is flush with the top and
bottom skins. If it bulges out, safely trim flush with
a Stanley knife.
B. Check if the steel bottom skin corner is bent
down below the bottom face. Bend it up with
pliers.
C. To increase weather protection turn up the
pans 15 degrees with a turn up/down tool or
equivalent as shown. (Non gutter end only)
Familiarize yourself with the weight and orientation
of the AD1 panel before lifting.
The panel end with 'top skin' overhang & sticker
must go to the rear.
The 'bottom skin' has a protective plastic coating,
this can be peeled off just before lifting.
Remember to lift and place do not slide, this can
scratch the panel.
4. Safely position the first panel on top of the
frame - all the way to the left.
The steel 'top skin' will sit over the rear flashing.
5. Adjust so it's butted up against the rear trim
and the side of the 'top skin' is flush with the end
of the flashing.
6. In the pan, fasten panel to rear beam with a tek
14 x 125 mm FAST104.
Don't over-tighten and crush the panel.
For further screw position detail see next page.
7. Check for consistent overhang along side
beam - adjust if required.
Fasten with a tek 14 x 125 mm FAST104 at the
midpoint of side beam.
8. In the pan, fasten to front beam with another a
tek 14 x 125 mm FAST104.
Model: ADGAZEBO33
21/09/23
1.00
7