Bose PowerShare PS404D Installation Manuals - Page 14

Browse online or download pdf Installation Manuals for Amplifier Bose PowerShare PS404D. Bose PowerShare PS404D 24 pages. Adaptable power amplifiers

Print Page

Installation

PowerShare Amplifier Network Connection

Before configuring your PowerShare PS604D/PS404D, download the latest version of ControlSpace Designer

at pro.Bose.com.

Connect the PS604D/PS404D either directly to a PC, or through an Ethernet switch via one of the two Dante

ports. Ensure that the PC is on the same subnet as the PS604D/PS404D using one of the following methods:

Set the PC to DHCP and connect a DHCP server to the network. Both the PS604D/PS404D and the

PC will obtain an IP address from the DHCP server.

Set the PC to DHCP and without a DHCP server. Both the PS604D/PS404D and the PC will obtain an

AutoIP-assigned IP address (link-local).

For more information, see the ControlSpace Designer software help system.

If all the network connections and settings are done correctly, ControlSpace Designer should automatically

identify the PowerShare amplifier on the network.

With a network connection in place and ControlSpace Designer software installed, use the Hardware Manager

tool inside ControlSpace Designer to scan and update the amplifier firmware.

For full details on using ControlSpace Designer to configure, control, and monitor the amplifier or systems

built with Bose networked system electronics, consult the ControlSpace Designer help system.

The reset procedure can be used on a PowerShare PS604D or PS404D amplifier to clear the project file

(programming defaults) and network settings.

Reset your amplifier to

clear all device settings to start from a factory default version.

resolve network issue where the IP address is unknown. The IP address will default to DHCP and if

DHCP server is not available, a link-local address will be used.

diagnose/resolve problems with a bad or incompatible project file.

The reset procedure can be done with the following steps. Read the whole procedure before following the

steps.

If possible, back up your CSD design before doing a reset because the amplifier's settings will be cleared

and default settings will be restored.

2. Turn the power off with the Power switch.

3. Wait over 10 seconds for power to fully discharge.

4. Use a paper clip (or similar tool) to depress the Reset button in the rear panel of the amplifier.

5. While depressing the Reset button, press the Power switch to turn the device power back on. The Input

Signal LEDs will light green.

6. Continue depressing the Reset button until the Input Signal LEDs are lit for four seconds, then release the

Reset button. The Input Signal LEDs will blink rapidly if the reset procedure was successful.

14 • English

PowerShare PS604D/PS404D • Installation Guide

pro.Bose.com