Bose Aviation Headset X Owner's Manual - Page 15

Browse online or download pdf Owner's Manual for Headsets Bose Aviation Headset X. Bose Aviation Headset X 36 pages. Owner's guide
Also for Bose Aviation Headset X: Owner's Manual (36 pages), Quick Setup Manual (1 pages), Owner's Manual (16 pages), Owner's Manual (36 pages)

Print Page

Figure 11

Attaching and removing the

cable

Figure 12

Harness connector and

schematic

CAUTION: Do not attempt to pull the connector out without first pulling

back on the sleeve. Forcing the connector out will cause damage to the cable

and/or your aircraft instrument panel.

Align keyway

Mounting the connector

Mount the connector into a cutout, as shown in Figure 12 below.

Connect the eight wires as follows:

• Two for the microphone

• Two for audio

• One for power

• One for ground

• Two for audio shields

Audio and microphone wires should be connected to the back of the

existing microphone and headphone jacks, leaving existing jacks

intact for use with conventional headsets. This is usually the fastest

installation method (see Figures 1 – 4 for reference). Audio shields

should be connected to ground at the existing jack.

(Caution: Use of two headsets wired in parallel is not advised. This

may result in reduced performance.)

Receptacle -

Panel Hole

Pinout

Required

(Front View)

12.5mm

Pin 6

.49"

14.0mm

.55"

Pin 1

ETTING

OUR

EADSET

Receptacle -

Backnut

(Side View)

M14 X 1

Front Nut

Hex Nut

Backnut

EADY FOR

Slide sleeve

to release

Aircraft

Interface

Schematic

RED

• 1 V+IN

BLK

• 2 GND

BLK/WH

WHT

• 3 COMM L

BLU

• 4 COMM R

WHT

• 5 MIC HI

WH/BLU

• 6 MIC LO

BLK/WH