Bose Aviation Headset X Owner's Manual - Page 17

Browse online or download pdf Owner's Manual for Headsets Bose Aviation Headset X. Bose Aviation Headset X 36 pages. Owner's guide
Also for Bose Aviation Headset X: Owner's Manual (36 pages), Quick Setup Manual (1 pages), Owner's Manual (16 pages), Owner's Manual (36 pages)

Print Page

Notes

• For use with a stereo intercom, connect the left and right channels

to their respective positions. If your intercom provides a monaural

audio signal, connect pins 3 & 4 together to the tip of the existing

phone jack.

• Do not use excessive force or bend the installed connector.

This may damage or break internal solder joints.

• If the boom microphone works on radio transmit but not through

the intercom, check pin 6. It may be incorrectly wired to the PTT

segment of the microphone jack.

• The wires connecting pins 3 & 4 and pins 5 & 6 are shielded,

twisted pairs with a shield termination exiting with a black/white

wire for each pair. Connect shields to existing audio wiring shields

or to audio ground, if existing wiring is not shielded.

• The Bose aircraft panel connector cannot be installed to an audio

system using transformer-coupled audio outputs. Call the Bose

Aviation Headset Department for details: 800-287-0611.

• Connecting power directly to pins 5 or 6 will result in damage to

the microphone.

• The wire guage is 22 AWG.

Adhesives approved for use with this connector are:

• VTCS-6 Vibratite

Do not let cyanoacrylate-based adhesives, flux remover, or other

caustic compounds contact the connector body. These chemicals

cause irreparable damage to the connector.

ETTING

OUR

EADSET

• Three Bond 1401

EADY FOR