Bose Lifestyle 35 Series II Installation Manual - Page 24

Browse online or download pdf Installation Manual for Headsets Bose Lifestyle 35 Series II. Bose Lifestyle 35 Series II 42 pages. Noise cancelling
Also for Bose Lifestyle 35 Series II: Installation Manual (36 pages), Owner's Manual (25 pages), Owner's Manual (24 pages), Owner's Manual (13 pages), Quick Setup Manual (3 pages), Operating Manual (46 pages), Owner's Manual (36 pages), Owner's Manual (32 pages), Quick Start Manual (2 pages), Factory Reset (2 pages), Quick Start Manual (2 pages), Owner's Manual (38 pages)

Print Page

ASIC

YSTEM

ONNECTIONS

Making sure the sound is as good as it gets

Figure 20

Setup discs and AdaptiQ

audio calibration system

Your system comes with two compact discs (Figure 20). Using them is the final step to

basic installation of your new LIFESTYLE

• Use Setup Disc 1 to verify that your speakers are connected correctly and for other tips you

may find useful.

• Use Setup Disc 2 to follow the ADAPTiQ

of your LIFESTYLE

system very specifically to the acoustics in your room.

The special headset, designed to be worn above your ears, takes acoustic measurements

for you during the process. Put on the headset only when prompted by Disc 2.

Setup Disc 1

• Play both discs when all of the speakers are where you want them, your furnishings are

arranged as intended, and all of the system connections are completed.

• Allow approximately 30 minutes to complete the process.

• Begin the process when you are unlikely to be disturbed and when the acoustic measure-

ment tones (not loud, just weird) are unlikely to disturb anyone else.

1. Use the TV remote to turn on your television.

2. Select the TV Video input used to connect to the media center.

Note: If you wrote down which input you used on the provided form, refer to that form in "Select-

ing the proper TV Video input is critical" on page 16.

3. Lift up the media center front cover and press Open/Close on the control panel.

4. Insert Setup Disc 1 into the tray (label side up) and press Open/Close again.

5. Using the remote control, press the CD/DVD button.

6. Listen carefully as the disc begins to play and follow the simple instructions until Disc 1

tells you it is time to play Disc 2.

Using Disc 2 for ADAPTiQ

Replace Disc 1 with Disc 2 in the disc tray and continue with the steps below:

1. Connect the ADAPTiQ calibration headset to the AUX jacks on the connection panel of

the media center as shown in Figure 21.

Français

DVD home entertainment system.

audio calibration process, which tailors the sound

ADAPTiQ audio calibration system

Setup Disc 2

ADAPTiQ calibration headset

audio calibration

Español

English