DAITEM SH272AX Installation Manual - Page 8

Browse online or download pdf Installation Manual for Security Sensors DAITEM SH272AX. DAITEM SH272AX 8 pages. Multicontact detector

Print Page

8. Maintenance

Recommendations

The user must not attempt to access the detector's internal

parts, except areas described in this manual. If the user does

access these parts, the product guarantee will be

considered null and void and DAITEM shall not be held

responsible for any problems. Touching the detector's

internal parts and/or electronic components can damage the

product. Furthermore, the detector is designed in such a

way that these parts and components do not need to be

accessed for operation or maintenance purposes.

8.2 Changing the battery

• The lithium battery pack must be replaced by the same type of pack with the same technical characteristics

(BatLi31 3 V - 1 Ah).

• We advise you to use the DAITEM BatLi31 pack available in the catalogue in order to guarantee individual

safety and equipment reliability.

• Dispose of the waste lithium power pack in an appropriate recycling bin.

To change the battery:

1. Switch the control panel to installation mode and ask the master user to press:

master code

The detector's conﬁguration is saved when the battery is changed.

2. Open the detector casing (see § on Opening).

3. Unclip the lithium battery pack.

4. Wait 2 min. before replacing the ﬂat lithium battery.

5. Close the detector.

6. Switch the control panel back to user mode. Press:

9. Technical data

Speciﬁcations

Built-in magnetic contact

Terminal block for external contact 1

Environment

Power supply

Battery life

Average humidity rate

Radio links

Test button

LED Indicator lamp

Operating temperature

Anti-tamper & protection

Degrees of mechanical protection

Dimensions L x W x H

Weight (with battery)

then

engineer installer code

Multicontact detector

building interior

DAITEM 3.6 V lithium battery

5 years in normal conditions of use

5% to 75% without condensation

at 25°C

TwinBand

400/800 MHz

battery and detection

-10 °C to +55 °C

• against opening and removal

• against loop cutting

IP 31/IK 04

138 x 26 x 30 mm

70 g

8.1 Battery low indication

The control panel indicates when the multicontact detector's

battery is low.

To check whether there is a problem with the detector

battery, press on the detector's test button.

IMPORTANT: if the test LED indicator

lamp no longer lights up, the lithium

battery should be replaced.

DECLARATION OF CONFORMITY

Manufacturer: Hager Security SAS

Address: F-38926 Crolles Cedex - France

Product type: Multicontact detector

Trade mark: Daitem

We declare under our sole responsibility that the product to which this

declaration relates is compliant with the essential requirements of the

following directives:

• R&TTE Directive: 99/5/EEC

• Low voltage directive: 2006/95/EC

• Directive ROHS: 2002/95/EC

in compliance with the following harmonised European standards:

Products code

EN 300 220-2 V2.3.1

EN 55022 & 55024 (2002)

EN 50130-4 (95) + A1 (98) + A2 (2002)

EN 60950 (2006)

EN 301 489-1 V1.8.1

This product can be used in all EU, EEA Countries

and Switzerland.

Crolles, 02.01.2013

Non-contractual document, may be modified without prior

notice.

"beep, installation

mode"

"beep, date,

time, off"

SH271AX

SH272AX

Signature:

Patrick Bernard

Director of Research and Development