DAITEM SH274AX Installation Manual - Page 8

Browse online or download pdf Installation Manual for Security Sensors DAITEM SH274AX. DAITEM SH274AX 13 pages. Contact detector
Also for DAITEM SH274AX: Installation Manual (4 pages)

Print Page

5. Testing

The contact detector has a "test" mode for testing:

• the battery: the LED indicator lamp lights up when the test button is pressed to indicate the battery is

working correctly,

• detection: the LED indicator lamp lights up when the contact changes status,

• the radio link: see § on Checking the radio links described in the control panel manual.

IMPORTANT: the control panel must be in installation mode for testing.

To test the detector:

• press the test button and the detector changes to test mode for about 90 sec. After this period the

detector automatically returns to normal operating mode,

In accordance with the new functional requirements of EN50131-2-6, the LED is factory defaulted to be

Inactive in Test Mode. To change this parameter, programme:

about 10 sec.

Commence

the sequence

by pressing the

on the required

test button until

parameter number.

the LED is off.

about

5 sec.

Press 2 times

Press and hold

depending

and then release the

test button as soon

as the LED lights

for the 2

1 or 2

Press the test 1 or 2

times to select the

required parameter.

• 1: inactive

time.

• 2: active.

about 10 sec.

about

2 sec.

Finish the

LED lights for 2

programming

seconds to

by pressing the test

confirm valid

button until the led

programming.

is off.