DSC TL280R Installation Manual - Page 10

Browse online or download pdf Installation Manual for Security System DSC TL280R. DSC TL280R 16 pages. Internet alarm communicator - international
Also for DSC TL280R: Installation Manuals (17 pages), Installation Manual (16 pages)

Print Page

1. Ethernet Programming Options

Trouble

Trouble Indic-

Indicator

ation

Digit

Yellow LED

–

8 Flashes

Yellow LED -

9 Flashes

Yellow LED

–

12 Flashes

Red and

Yellow LEDs

N/A

flashing

together

The programming sections described in this document can be viewed at the keypad LCD. To start programming enter: [*][8]

[installer code][851][section number], where section number is the 3-digit section number referenced in this section. The pro-

gramming worksheets at the end of this document can be used to record the new values when programming changes have

been made from the default values.

Possible

Causes

address and port number.

Receiver

This trouble is indicated when supervision is enabled and the unit is not able to

Supervision

successfully communicate with the receiver.

If this trouble persists, contact the central station.

Trouble

The unit has exhausted all communications attempts to all programmed

FTC Trouble

receivers for events generated by the communicator.

Restart the system, if trouble persists, contact the dealer.

Module

This indication appears when section [021] system account code or sections

[101] or [111] receiver account code have not been programmed. Ensure that a

Configuration

valid account code has been entered in these sections.

Trouble

The unit is still initializing please wait while the unit gets its programming and

Initialization

establishes a connection to all programmed receivers.

Sequence

NOTE: This process may take several minutes to complete.

If the initialization sequence is taking more than several minutes, the boot loader

might have failed.

Confirm that the boot loader has failed by entering communicator programming

Boot Loader

[*][8][installer code][851].

Failed

If access is granted, continue waiting for the initialization sequence to complete.

If access is denied (long error tone), disconnect power from, then reconnect

power to the communicator module.

Ethernet Programming Options

Trouble Possible Solution