DSC TL280R Installation Manuals - Page 6

Browse online or download pdf Installation Manuals for Cell Phone DSC TL280R. DSC TL280R 17 pages. Internet alarm communicator - international
Also for DSC TL280R: Installation Manual (16 pages), Installation Manual (16 pages)

Print Page

Communicator Installation Configuration

OMMUNICATOR

This Ethernet Communicator shall be installed by service persons only (service person is defined

as a person having the appropriate technical training and experience necessary to be aware of haz-

ards to which that person may be exposed to in performing a task and can also take measures to

minimize the risks to that person or other persons). The Communicator shall be installed and used

within an environment that provides the pollution degree max 2, overvoltages category II, in non-

hazardous, indoor locations only. This manual shall be used with the installation manual of the

panel which is connected to the Ethernet communicator. All instructions specified within the panel

manual must be observed.

All the local rules imposed by local electrical codes shall be observed and respected during instal-

lation.

NSTALLING

Installing Communicator with HS2016, HS2032, HS2064, and

HS2128 Panel

1. To assemble supplied mounting bracket, perform the following: (see Figure 1).

a. Remove the 4 white plastic standoffs

from the bag provided with the com-

municator kit.

b. Insert the 4 standoffs through the back

of the mounting bracket, into the holes

at each corner.

c. Place the bracket on a flat, solid sur-

face. Hold the communicator compo-

nent side up and orient the 4 holes on

the communicator with the 4 standoffs

protruding from the bracket. Push the

communicator firmly and evenly onto

the standoffs until it is securely

attached to the mounting bracket.

d. Remove the panel front cover.

e. Remove and discard the circular knockout located

in the top-right section of the panel.

2. Install the Communicator into the panel:

a. Attach one end of the PC-LINK cable to the panel

PC-LINK header on the panel (red wire goes on

the right-hand pin of the panel PCLINK_2 header

(see Figure 3)).

b. Insert the assembled communicator into the panel.

c. Locate the screw hole on the right side wall of the

panel (see Figure 2 (screw)). Line up the assem-

bled communicator with the right side wall of the

panel and, using the screw provided, secure the

mounting bracket to the panel.

d. Attach the other end of the PC-LINK cable to the

communicator (red wire goes on the right-hand pin

of the communicator PC-LINK header (see Fig-

ure 3)).

e. Using light pressure (finger tight only), attach the supplied white quad band whip antenna to

the threaded antenna connection point at top of the panel.

WARNING! - Modules are power limited. Do not route any wiring over the circuit board.

Maintain at least 1in. (25.4mm) separation between circuit board and wiring. A minimum

of ¼ in. (7mm) separation must be maintained at all points between non-power limited

wiring and power limited wiring.

3. To electrically connect the communicator to the panel, perform the following steps (see Figure 3).

NSTALLATION

THERNET

Mounting Holes

Communicator

Board

Internet Alarm Communicator Installation Guide

ONFIGURATION

OMMUNICATOR IN

Figure 1:Communicator Mounting Bracket

Stand Off

Mounting

Plate

Figure 2:HS2016/2032/2064/2128 Control Panel

cable connector

HS2016/2032/2064/2128

ANEL

Mounting

Holes

Mounting Plate

PC-Link

GSM Radio

RJ-45

screw