DTM System DTM-SWIFT 350 Assembly Instructions For The Installer - Page 4
Browse online or download pdf Assembly Instructions For The Installer for Controller DTM System DTM-SWIFT 350. DTM System DTM-SWIFT 350 16 pages. Actuators for swing gates
Print Page
PLEASE START BY READING THE IMPORTANT SAFETY RULES!
Non-observance and non-compliance with the notes marked with these symbols may lead to an accident in which
people will be injured or property damage will occur. Please read these warnings carefully. The gate drive ensures
correct and safe operation only if the installation and use comply with the following safety rules. DTM System is
not responsible for accidents resulting from improper use or unprofessional installation of devices.
When installing or repairing the automatic gate, be careful
not to wear jewelery, watches or loose clothing.
Lay the electric wires in accordance with the local building
and electrical installation regulations. Electric cables may
only be connected to a properly grounded network by an
authorized electrical engineering specialist.
Remove any locks installed on the gate to avoid
damaging it.
After installation, it is necessary to check that the
mechanism is correctly set and that the drive, restraint
system and emergency unlocking function properly.
The gate drive cannot be started and continue to
operate when there is a wicket in the gate and it is not
properly closed.
Any possible movement of the gate towards the wall
should be blocked or limited (e.g. by installing limiters).
Thanks to this, we will eliminate the possibility of being
crushed while opening the gate.
Warranty.
DTM System delivers the equipment in working order and ready for use and provides a warranty for a
period of 24 months from the date of purchase by the end customer. The warranty period is determined on the
basis of warranty seals. DTM System undertakes to repair the device free of charge if during the warranty period
there are defects due to the manufacturer's fault. The defective device must be delivered to the place of purchase
at your own expense, with a short, unambiguous description of the damage. The cost of disassembly and
assembly of the device is borne by the user. The warranty does not cover any damage resulting from improper use,
unauthorized adjustments, alterations and repairs as well as damage caused by lightning, overvoltage or short
circuit in the power supply network. The detailed terms and conditions of granting a guarantee are regulated by
relevant legal acts.
The gate should always move freely. A jammed gate must
be repaired immediately. Do not try to repair the gate
yourself. A specialist should be employed for this.
Keep additional accessories away from children. Do not
allow children to operate the control buttons or the remote
control. It should be remembered that an automatic gate is
a device in which the risk of serious injury cannot be
completely eliminated in the event of remote operation,
not controlled by an adult.
Control devices should allow for visual verification of the
gate itself and its immediate surroundings.
During maintenance work, such as cleaning, lubrication,
etc., the gate automation must be disconnected from
the mains. In the electric installation of the gate, a device
for disconnecting all phases by means of a switch
(distance between contacts at least 3mm) or separate
fuses should be provided.
Please make sure that the persons who install, maintain
or operate the gate automation follow these
instructions. Keep these instructions in a place where you
can refer to them quickly when needed.
Crush or injury protection systems (e.g. photocell
systems) must function properly after the drive has been
mounted and connected to the mains.