Anyload EC200 Operating Manual - Page 3

Browse online or download pdf Operating Manual for Scales Anyload EC200. Anyload EC200 16 pages.
Also for Anyload EC200: User Manual (8 pages)

Print Page

1 Safety

1.1 Representations and symbols

Important instructions, which involve safety, are highlighted with the appropriate mark:

When using the weighing equipment in surroundings with increased safety requirements,

the corresponding regulations must be observed.

The weighing machine may only be used with the power adapter supplied exclusively for use with

the weighing machine.

Before inserting the power adapter, the user must ensure that the operating voltage stated on the

power adapter agrees with the mains voltage.

If not, please contact Customer Service at the address above.

If the power adapter or its cable is damaged, the weighing machine must immediately be

disconnected from the electricity supply (pull out the power adapter).

The weighing machine may only be operated from mains electricity supply with a power adapter which

is in perfect condition.

If there should be any reason to believe that it is no longer possible to operate the weighing machine

without danger, the weighing machine is to be immediately unplugged from the electricity supply (pull

out power adapter) and secured against inadvertent operation.

In carrying out maintenance work, it is essential to follow the recommendations in Chapter 6

Maintenance and service.

The weighing machine must not be operated in an area subject to explosion risks.

Care must be taken when weighing liquids to ensure that no liquid is spilt into the inside of the

weighing machine or into connections on the rear of the equipment or the power adapter. If liquid is

spilt on the weighing machine, it must immediately be unplugged from the mains electricity supply (pull

out power adapter).

The weighing machine may only be operated again after it has first been re-checked by a

service technician.

These operating instructions must be read by each operator of the equipment and must be available

at the workplace at all times.

Page 3 of 16

AL-manual-EC200-En-V2