AnyTone AT888 User Manual - Page 7
Browse online or download pdf User Manual for Radio AnyTone AT888. AnyTone AT888 20 pages.
Print Page
2
Initial Installation
Use the full length of the cable without cutting off excess even if
cable is longer than required. In particular, never remove the fuse
holders from the cable.
51
Reconnect any wiring removed from the negative terminal.
61
Connect the DC power cable to the transceiver's power supply
connector.
Press
the connectors firmly together until the locking tab clicks.
3
Ext. Power jack
Fixed Station Operation
In order to use this transceiver for fixed station operation, you will
need a separate 13.8V DC power supply (not included), power
supply( QRP-01) as optional accessories. Please contact local dealer
to require.
The recommended current capacity of your power supply is 12A.
Red
Black
DC power cable
11
Connect the DC power cable to the regulated DC power supply
and ensure that the polarities are correct. (Red: positive, Black:
negative).
Do not directly connect the transceiver to an AC outlet.
Use the supplied DC power cable to connect the transceiver to a
regulated power supply.
the
Do not substitute a cable with smaller gauge wires.
Regulated power supply (QRP-01)
21
Connect the transceiver's DC power connector to the connector
the DC power cable.
Press the connectors firmly together until the locking tab clicks
Before connecting the DC power to the transceiver, be sure to
switch the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make
all connections.
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem. After
the problem is resolved, replace the fuse. If newly installed fuses continue
to blow, disconnect the power cable and contact your autho-rized
dealer or an authorized
Mobile Radio
assistance.
Regulated
power supply
(QRP-01)
Red
Black
DC power cable with fuse holder (QPL-01)
The EUT can be used on the vehicle.
Mobile Radio
2
on
.
servi-cecenter for